Download Print this page
Waterax striker 2/3 Quick Manual

Waterax striker 2/3 Quick Manual

Advertisement

Quick Links

STRIKER-2/3 Quick Guide
This Quick Guide shows the basic operation of the
WATERAX STRIKER-2/3 multi-stage high pressure pump.
The WATERAX STRIKER-2/3 pairs a WATERAX 2-
stage or 3-stage pump end with a Honda GX390
gasoline engine. For instructions regarding the engine,
as well as for oil and fuel recommendations, please refer
to the engine manufacturer's manual.
For detailed instructions on using and troubleshooting
your pump, as well as full service and maintenance
instructions, refer to our website to download the
STRIKER-2/3 Owner's Manual.
For full specifications and performance curves, see the
STRIKER-2/3 Data Sheet.
Warnings and Safety Precautions
This warning label appears on all WATERAX pumps to identify safety
hazards as follows:
READ YOUR ENGINE MANUAL!
Before proceeding further, locate and read the engine
manufacturer's manual. It contains very important safety
information that MUST be read, understood and followed to
safeguard you and your equipment from harm, as well as for
the proper use and care of your engine. Use only fuel and
oil type recommended in the engine manufacturer's manual.
Always check oil level in crankcase before use.
WEAR EAR AND EYE PROTECTION.
Always wear eye and ear protection when operating the
pump unit. Sound level of the unit: 94 dB(A).
GENERAL WARNINGS:
Do not operate if mentally or physically fatigued.
Inspect hoses and piping to avoid burst injuries.
No modifications and/or alterations may be made to the
pump. Any such modifications void the pump warranty
and can endanger pump operators.
Do not operate the pump above the maximum rated
pressure. Use only pipe, hose, and fittings rated at or
above the maximum pressure rating of the pump or
system design.
Slowly close valves. Use slow close valves wherever
possible to safeguard operators and prevent damage
from water hammer.
Dry weight of the unit: approximately 127 lbs (will vary
depending on options).
01/2015
READ THE PUMP OWNER'S MANUAL!
The improper use of this pump could result in serious injuries
as well as damage to the unit. Read the STRIKER-2/3
Owner's Manual before using your STRIKER pump unit and
follow the safety instructions in this Quick Guide.
NEVER RUN THE ENGINE IN A CLOSED
OR CONFINED AREA. Exhaust gas contains
carbon monoxide which is poisonous to humans.
Avoid inhalation of exhaust gas.
REFUEL ENGINE WITH CARE. Gasoline is
extremely flammable, and gasoline vapor can
explode. Refuel in a well-ventilated area, with the
engine stopped.
NEVER TOUCH ANY EXHAUST SYSTEM
PARTS WHILE ENGINE IS RUNNING. Always
allow enough time, after stopping the unit, for proper
cooling of these parts and surrounding areas.
EQUIPMENT DAMAGE PREVENTION:
Flush the pump with fresh water if the pump has been
used to pump salty, brackish, high mineral content
water, water containing debris, or foam injected water.
Check that debris is cleared before using the pump
again.
Always draft water using a suction hose strainer.
1

Advertisement

loading

Summary of Contents for Waterax striker 2/3

  • Page 1 For full specifications and performance curves, see the  STRIKER-2/3 Data Sheet. Warnings and Safety Precautions This warning label appears on all WATERAX pumps to identify safety hazards as follows: READ YOUR ENGINE MANUAL! READ THE PUMP OWNER’S MANUAL! Before proceeding further, locate and read the engine The improper use of this pump could result in serious injuries manufacturer’s manual.
  • Page 2 STRIKER-2/3 Quick Guide Parts Identification Pump intake (suction) Pump drain port (not shown) Priming valve Quick release pump clamp Discharge check valve* Pump discharge Hand primer* Ignition switch Recoil starter Fuel cap Throttle (not shown) Fuel valve (not shown) Choke (not shown) Muffler Note: Portable 2-stage pump model shown.
  • Page 3 STRIKER-2/3 Quick Guide 4. Prime the pump. Check that all drains, discharge valves, or any auxiliary valves are closed before priming the pump. Open the priming ball valve (located between the pump and the primer). Manual Priming: If the unit is equipped with a hand primer, open the priming valve located below the Vehicle-mount discharge check valve and prime the pump until a...
  • Page 4 Warranty, Service and Support Product and service documentation such as tech notes, data sheets, manuals and information on the limited warranty provided on products manufactured by WATERAX can be found on our Web site at: www.waterax.com WATERAX Inc. 6635 Henri-Bourassa W.