Hydraulic System; Cooling System; Engine Oil Level Check - Dennis POINTER Operation Manual

Maintenance Checks

Hydraulic System

The hydraulic dipstick and filler is
situated to the right of the engine on the
frame upright.
The oil level should be checked with
the engine idling.
Maintain the level between the High
and Low marks.
LOW HIGH

Cooling System

The coolant level should be checked
when the engine is cold or after 15
minutes if the vehicle has been
running.
If coolant needs adding, top up with
50/50 mix of soft water/antifreeze
solution.
The header tank filler cap is situated at
the rear right hand side of the vehicle.
50% WATER
+
50% ANTIFREEZE
WARNING
Allow the system to cool
sufficIently before removing
the header tank filler cap as
faIlure to do so can cause
personal injury from heated
coolant spray.
Engine Oil Level
The engine oil dipstick is situated at the
rear of the vehicle with the oil and fuel
fillers.
The correct oil level should register on
the cross hatched area. Never operate
the engine with the oil level below the
cross hatched area or above the full
mark.
NOTE
Wait at least five minutes
after stopping the engine
to check the oil level, this
allows the oil to drain into
the sump.
FULL
57