Abus TVIP70000 User Manual page 34

Explanation of symbols
The triangular high voltage symbol is used to warn of the risk of
injury or health hazards (e.g. caused by electric shock).
The triangular warning symbol indicates important notes in these operating instructions
which must be observed.
This symbol indicates special tips and notes on the operation of the unit.
Important safety information
All guarantee claims become invalid for damages caused by non-compliance with these
operating instructions. We cannot be held liable for resulting damages.
We cannot be held liable in the event of material or personal damages caused by
improper operation or non-compliance with the safety information. All guarantee claims
are invalid in such cases.
The following safety information and hazard notes are not only intended to protect your health, but
also to protect the device from damage. Please read the following points carefully:

There are no components inside the product that require servicing. Dismantling the product also
invalidates the CE certification and guarantee claims/warranty.

The product can be damaged if it is dropped, even from a low height.

This device is designed for indoor use.

Install the device so that the image sensor is not subjected to direct sunlight. Pay attention to the
installation instructions in the corresponding chapter of these operating instructions.
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Extreme heat or cold

Direct sunlight

Dust or flammable gases, vapours or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

The camera must not be installed on unstable surfaces
General safety information:

Do not leave packaging material lying around. Plastic bags, sheeting, polystyrene packaging etc. can
pose a danger to children if played with.

The surveillance camera contains small parts which could be swallowed, and should be kept out of
reach of children for safety reasons.

Do not insert any objects into the device through the openings.

Only use replacement devices and accessories that are approved by the manufacturer. Do not
connect any non-compatible products.

Please pay attention to the safety information and operating instructions for the other connected
devices.

Check the device for damage before commissioning. Do not put the device into operation if damages
are detected.

Adhere to the operating voltage limits specified in the technical data. Higher voltages could destroy
the device and pose a health risk (electric shock).
34