Storage; Service Parts; Accessories - Ariens Sno-Thro ST20E Owner's/Operator's Manual

STORAGE

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SHORT TERM
IMPORTANT: NEVER spray unit with high
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any
loose or melting snow.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
Maintenance). Touch up all scratched painted
surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
FUEL SYSTEM
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer according to
manufacturer's instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.

SERVICE PARTS

Order the following parts through your
Dealer:
Part No. Description
00036800 Ariens Hi-Temp Grease (3, 3 oz.
cartridges)
21534100 Spark Plug
07200108 Impeller Belt
07200109 Stretch Fit Traction Belt
53200500 Shear Bolts
00592900 Gas Stabilizer (4 oz.)

ACCESSORIES

See your authorized Ariens dealer to add the
additional accessories available to your
Sno-Thro.
Part No. Description
73203100 Slicer Bar
72600300 Composite Skid Shoe Kit
73203600 Sno-Thro Cover
GB - 27