Table of Contents General Introduction ........................1 Overview ........................1 Functions ........................1 Specifications ........................1 Framework...........................3 Rear Panel........................3 Side panel........................4 Front Panel ........................5 Installation ...........................6 Lens Installation......................6 I/O Port Installation.......................7 Menu.............................8 Appendix Toxic or Hazardous Materials or Elements ...............12...
Page 3
Welcome Thank you for purchasing our HDCVI camera! This user’s manual is designed to be a reference tool for your system. Please read the following safeguard and warnings carefully before you use this series product! Please keep this user’s manual well for future reference!
Important Safeguards and Warnings 1.Electrical safety All installation and operation here should conform to your local electrical safety codes. The power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the Limited power source is rated 12V DC or Ac 24V in the IEC60950-1. We assume no liability or responsibility for all the fires or electrical shock caused by improper handling or installation.
Page 5
Please shut down the device and then unplug the power cable before you begin daily maintenance work. Use the dry soft cloth to clean the device. If there is too much dust, please use the water to dilute the mild detergent first and then use it to clean the device. Finally use the dry cloth to clean the device. Please put the dustproof cap to protect the CMOS component when you do not use the camera.
1 General Introduction 1.1 Overview This series megapixel HD camera conforms to the HDCVI standard. It supports video signal high-speed long distance transmission without any delay. The HDCVI port adopts coaxial cable and uses BNC port as the standard cable. This series product has megapixel definition.
Page 7
1280(H)×960(V) Sensor Pixel Color: 0.01Lux@(F1.2,AGC ON), Illumination Black and white: 0.001Lux@(F1.2,AGC ON), Electronic 1/1s~1/10000s@ (slow shutter*512) Shutter Video Standard HDCVI/CVBS compliance Video Frame 1280*720@25fps ;1280*720@30fps Rate Day/Night ICR mechanical auto switch Switch Lens Port C/CS Auto Iris DC Drive WDR Range 120dB Audio/Video Support audio/video transmission over the same coaxial cable.
2 Framework 2.1 Rear Panel Please refer to the following figure for the rear panel information. See Figure 2-1. Figure 2-1 Port Name Connector Port Function Power port. AC 24V/ DC Power port Connect to AC 24V/ DC 12V. Power light. The light is on after system boots Indicator Red light light...
Port Name Connector Port Function Ground end. RS485_A port. Connect to DVR or RS485 configuration tool to set video parameters. RS485 port RS485_B port. Connect to DVR or RS485 configuration tool to set video parameters. Reserved Reserved port For R/D use only. Press it for five seconds, system can reload RESET Reset button...
3 Installation Important Before the installation, please make sure the installation surface can sustain at least 3X weight of the bracket and the camera. 3.1 Lens Installation Please refer to the steps listed below for installation information. See Figure 3-1 and Figure 3-2. Remove the protection cap from the device.
Figure 3-2 3.2 I/O Port Installation Install Cable Please follow the steps listed below to install the cable. See Figure 3-3. Use the small slotted screwdriver to press the corresponding button of cable groove. Insert the cable into the groove and then release the screwdriver. Remove Cable Please follow the steps listed below to remove the cable.
4 Menu Important Please check the current video output mode when there is no video output. The yellow light is on when system is outputting standard definition video. The yellow light is off when system is using high definition video. THE 1ST MENU THE 2ND MENU THE 3RD MENU...
Page 14
/1500,1/2000,1/3000,1/4000,1/60 00,1/10000. SLOW SHUTTER PAL: 1/1,1/2,1/3,1/6,1/12,1/25,1/50,1/7 5,1/100,1/120 NTSC: 1/1, 1/2, 1/4, 1/8, 1/15, 1/30,1/60, 1/90,1/100,1/125 BACK GAIN -1,0,2,4,6,8,10,12,14,16,18,20,22,24,26,28(DB) LENS It is read-only on auto shutter mode. OFF,+0,+1.+2,+3,+4,+5,+6,+7,-1,-2,-3,-4,-5,-6,-7 0,5,10,15,20,25,30,35,40,45,50,55,60,65,70,75,80,85,90,95,1 BACK MANUAL SHUTTER PAL: 1/25, 1/50, 1/75, 1/100, 1/120, 1/150, 1/215, 1/300, 1/425, 1/600, 1/1000, 1/1250, 1/1750, 1/2500, 1/3500, 1/6000, 1/10000 NTSC:...
Page 15
OFF, 1, 2 OFF,1, 2 BACK IMAGE MODE CUSTOM , FLAMBOYANT,SOFT, Note: For non-custom mode, the rest parameters are read-only. HUE CNT 00~15 SHARPNESS 00~15 SHARP CNT 00~15 BRIGHT 000~255 SATURATION 000~255 000~255 GAMMA 00~15 BACK ADVANCED MOTION DETECT… ON/OFF ON/OFF DISPLAY ON/OFF...
Appendix Toxic or Hazardous Materials or Elements Toxic or Hazardous Materials or Elements Component Name Cr VI PBDE Circuit Board ○ ○ ○ ○ ○ ○ Component Device Construction ○ ○ ○ ○ ○ ○ Material Wire and Cable ○ ○...
Need help?
Do you have a question about the HAC-HF3101 and is the answer not in the manual?
Questions and answers