Wash Cycles - Indesit IWDC 6145 Instructions For Use Manual

Table of Contents

Advertisement

Available languages

Available languages

Connecting the drain hose
!
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the washer-dr-
yer. If this is not the case, replace the socket or the plug.
!
The washer-dryer must not be installed outdoors, even
in covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
!
When the washer-dryer has been installed, the electricity
socket must be within easy reach.
!
Do not use extension cords or multiple sockets.
Connect the drain hose,
without bending it, to a drai-
nage duct or a wall drain
located at a height between
65 and 100 cm from the
floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not be
underwater.
!
The cable should not be bent or compressed.
!
The power supply cable must only be replaced by autho-
rised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the wash cycle 2.
Technical data
Model
IWDC 6145
width 59.5 cm
Dimensions
height 85 cm
depth 53,5 cm
from 1 to 6 kg for the wash programme;
Capacity
from 1 to 5 kg for the drying programme
Electrical
please refer to the technical data plate fixed
connections
to the machine
maximum pressure 1 MPa (10 bar)
Water con-
minimum pressure 0.05 MPa (0.5 bar)
nections
drum capacity 52 litres
Spin speed
up to 1400 rotations per minute
Wash: programme 2; temperature 60°C;
Energy rated
run with a load of 6 kg.
programmes
Drying: first drying cycle performed with a 1 kg
according to
load, by selecting a drying time of 60 min;
regulation
Second drying cycle performed with a 5 kg load
EN 50229
and the DRYING knob on the
This appliance conforms to the following EC
Directives:
- 89/336/EEC dated 03/05/89 (Electro-
magnetic Compatibility) and subsequent
modifications
- 2002/96/EC
- 2006/95/EC Low Voltage)
GB
setting.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents