Digital Display; Timer; Desired Humidity - Whirlpool AD50GUSB Use & Care Manual

Desired Humidity

Press MODE to select the desired humidity setting.
2. Choose Auto Dry,
Auto Dry: Will operate the dehumidifier only in the dry mode.
■
Auto Fan Speed is set automatically. The Desired Humidity
is set to 50% automatically.
Continuous: Will operate the dehumidifier continuously
■
The Fan Speed can be adjusted. The Desired Humidity can
not be adjusted. The LED display will show the room humidity
level.
■ Normal: Will operate the dehumidifier at the selected fan
speed and desired humidity. If the humidity levels of the
room is higher than the desired humidity setting, the compressor
will turn on. If the humidity level of the room is lower than
the desired humidity setting, the compressor will turn off.
NOTE:
The de-icer will turn off the compressor if a low temperature
condition exists. Pressing the Desired Humidity button or the
plus or minus arrow button will not increase or decrease the
amount of moisture removed. When the de-icer senses the
correct operating temperature, the compressor will cycle back
on.
Humidity Level
1.
Press the Plus or Minus button to activate the humidity setting
program. Digits in the digital display will flash.
2.
Press the Plus or Minus button again to set your desired
humidity.
3.
Digital display will stop flashing five seconds after setting.
Room humidity will be displayed.
NOTE:
Humidity can only be adjusted manually in Normal mode.
In Continuous and Auto Dry mode, humidity level is set automatically.

Digital Display

Display shows relative humidity or time (depending on setting).
■ When the dehumidifier operates in Desired Humidity modes,
the display shows the relative humidity of the room.
■
When the timer is selected, the display shows the time when
the dehumidifier will turn on or turn off, depending on the setting.
Downloaded from www.Manualslib.com
Continuous or Normal .
.
manuals search engine
■
For heat function model, when the dehumidier operaties
in heat mode, the display shows the room temperature.
NOTE:
The humidity displayed is only for reference. For accurate humidity,
please check a hygrometer.

Timer

To set Timer for a 30-minute to 24-hour delay before the
dehumidifier is turned off (the dehumidifier must be On):
1. Press TIMER. Timer indicator light will come on, the Display
will flash. the display will show remaining hours before the
dehumidifier will turn off.
2. Press the Plus or Minus arrow button to change the delay
time, from 30 minutes to 24 hours.
3. After five seconds, the Timer indicator light will remain on.
The display will show the current relative humidity of the room,
or show the current temperature of the room if it operating
in heat mode for some model.
To set Timer to turn on the dehumidifier, keeping previous
setting:
1. Turn off the dehumidifier.
2. Press TIMER. Timer indicator light will flash. The display will
show remaining hours before the dehumiditier will turn on.
3. Press the Plus or Minus arrow button to change the delay
time, from 30 minutes to 24 hours.
4. After five seconds, the Timer indicator light will remain on.
The display will show the current relative humidity of the room.
or show the current temperature of the room if it operating
in heat mode for some model.
To clear the Timer delay program:
Dehumiditier can be either on or off.
NOTE:
1. Press TIMER once after it has been programmed. Display
will show remaining time.
2. While the display is showing the remaining time, press TIMER
again. Timer indicator light will turn off.
To see or change the remaining time.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press the
Plus or Minus button to increase or decrease the time.
3. After five seconds, the display will show the room's current
relative humidity.
6
.