Config Menu - Lenovo ThinkPad P40 Yoga User Manual

Config menu

To change the configuration of your computer, select Config tab from the ThinkPad Setup menu.
The following table lists the Config menu items. Default values are in boldface. The menu items might
change without notice. Depending on the model, the default value might vary.
Attention: The default configurations are already optimized for you. Improper change of the configurations
might cause unexpected results.
Table 3. Config menu items
Menu item
Network
Submenu item
Wake On LAN
UEFI IPv4 Network Stack
(for UEFI Only boot mode
or Both with UEFI first)
UEFI IPv6 Network Stack
(for UEFI Only boot mode
or Both with UEFI first)
UEFI PXE Boot Priority
(for Both with UEFI first
boot mode, and IPv6
and IPv4 stacks are both
enabled.)
Selection
• Disabled
• AC Only
• AC and Battery
• Disabled
• Enabled
• Disabled
• Enabled
• IPv6 First
• IPv4 First
Chapter 6
Comments
Enable the computer to power
on when the Ethernet controller
receives a magic packet (a
special network message).
If you select AC Only, Wake on
LAN is enabled only when the ac
power adapter is attached.
If you select AC and Battery,
Wake on LAN is enabled with
any power sources.
Notes:
• The magic packet type Wake
on LAN requires ac power.
• The Wake on LAN function
does not work when a hard
disk password is set.
Enable or disable Internet
Protocol Version 4 (IPv4) network
stack for the UEFI environment.
Enable or disable Internet
Protocol Version 6 (IPv6) network
stack for UEFI environment.
Select network stack priority for
UEFI PXE boot.
.
Advanced configuration
71