CONCORD Wanderer Manual page 13

As shown, pull out the crotch strap from the prior
plastic eyelets on the harness lock. Regularly check
the position of the plastic parts, as well as the safe
function of the harness system!
Place the back plate in the closable bag on the rear
of the cover and press the Velcro fastener together.
To install the cover, first thread the cover through
the central aperture in the upper area of the tube
frame and into the Keder rail on the right and left.
Move the cover downwards until it is in the correct
position.
Subsequently, thread the right end of the cover of
the footrest into the aperture of the Keder rail on
the inside of the footrest on the left.
Move the cover fully to the right and thread the left
end into the Keder rail.
42
The individual parts of the cover of the CONCORD
WANDERER are connected together and secured
to the tube frame using press studs and Velcro
fasteners.
Close all of these connections.
Replace the straps from the tilt
adjustment system and thread
these as shown through the
plastic eyelets.
Check to ensure that all straps
are correctly positioned and
secured.
As one final check, make sure that the cover is correctly anchored in the
Keder rail, and that all fasteners and connectors are securely closed.
43