Table of Contents
Advertisement
!
1.1.3. The bottom side
The headphone socket is located on the bottom side of the device. When connected,
audio is output directly through the headphones, instead of the internal speaker. Your
Milestone 112 Ace memorizes separate volume levels for speaker and headphones.
1.2. Using the interface ports
1.2.1. Battery charging via USB connector
Connect the charger provided with your Milestone 112 Ace to a power outlet. Plug the
other end of the charger cable into the mini-USB-socket, located at the center of the
Milestone´s top side. The connection was successfully established, once you hear a low
beep and the LED light on the user interface starts flashing every 3 seconds. The device
will be fully charged after 3 hours. Please note that a connection to a computer via USB-
cable also recharges the battery, as long as the computer remains powered on. You can
check the battery´s charging status by using the Milestone 112 Ace´s „Information Service"
function, described under chapter 2.4 of this manual.
1.2.2. Headphones
If you prefer to use headphones with your Milestone 112 Ace, rather than the built-in
speaker, simply plug in any standard headphones with a 3.5 mm jack into the socket
located at the bottom side of the Milestone.
Please note that your Milestone memorizes two separate volume levels. One for its
internal speaker and another for connected headphones.
1.2.3. Connecting to a computer via USB and backing up your data
In order to back up your data, connect your Milestone 112 Ace to a computer via USB-
cable. The built-in USB 2.0 Hi-Speed port allows for quick transfer times.
Plug the smaller end of the cable into the mini-USB-connector, which is located at the
center of the top side of your Milestone 112 Ace.
The larger end connects to a standard USB-port on your computer. Your Milestone 112
Ace will confirm a successful connection to your computer with the message „connection
activated".
The device will then be accessible on your computer as an external drive, named
"M112ACE". Once the data transfer is complete, please make sure that you remove your
Milestone 112 Ace drive safely from your computer, as you would do with a USB-stick.
Milestone will acknowledge that it was properly disconnected from the computer with the
audible message „connection deactivated".
Helpful hint: We highly recommend you to back up your data from the internal memory of
your Milestone 112 Ace to your computer's hard drive on a regular basis.
1.2.4. Connecting an external audio source via line-in socket
The line-in socket, located to the right of the USB-port, can be used to record from any
external audio source, such as microphones, CD-players or radios. Simply connect the
external audio source to the line-in socket of your Milestone 112 Ace with a regular stereo
audio cable, featuring a standard 3.5 mm jack. Please refer to the chapter "Recording from
external audio sources" for more detailed information.
2
/8
Hide quick links:
Advertisement
Table of Contents
