Makita LS1216 Instruction Manual page 11

Net weight
For all countries other than European countries
For European countries
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 1/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･
Do not place hand or fingers close to
the blade.
･
Never look into the laser beam. Direct
laser beam may injure your eyes.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
with household
equipment and
environmentally compatible
END210-6
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN61029:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
waste
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
its
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENE006-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
11
LS1216L/LS1216F ...26.4 kg
LS1216FL ...26.5 kg
LS1216L/LS1216F ...26.6 kg
LS1216FL ...26.7 kg
A-weighted noise level
) : 91 dB(A)
pA
) : 100 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s
h
2
LS1216...26.3 kg
LS1216...26.5 kg
/II
ENF002-2
ENG905-1
determined
ENG900-1
vector sum)
or less
ENG901-1