Disassembly Of Lower Case - LG -500 Service Manual

Gsm phone

Hide thumbs Also See for LG-500:

Table of Contents

4.1.3 Disassembly of Lower Case

1. Use a '-' type driver to release from the hooks on Lower case.

Then, lift up the PCB for final disassembly.

2. Insert a small '-'type driver between the shield-can and cover, and lift up along the flat side of the

lower case.

3. Lift up the rubber part of multi-key, and then the Dial BTN will be disassembled from the Lower

Case.

4. While holding the Lower case with your left hand, use your right hand to twist the flip-cover to the

hinges.

Assembly : Leave the flip cover open and insert one side of the flip-cover into the hinge as

shown in fig.4-6. Then twist the flip-cover when inserting the other end. DO NOT use

too much force onto it. Make sure the flip is working properly, after the assembly.

Figure 4-5. Removing the PCB

Figure 4-6. Removing the Flip

- 16 -

Table of Contents