Cleaning And Usage Of The Icemaker; Cleaning The Ice Cube Tray; Icemaker Usage Precautions - Haier HB25FSSAAA User Manual

Hide thumbs Also See for HB25FSSAAA:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Cleaning and usage of the icemaker

Cleaning the ice cube tray

1. Turn off the icemaker function via the display panel, hold
down the handle of the icemaker, and use strength to pull
out the icemaker.
2. Remove the icemaker assembly from the refrigerator and
turn over the icemaker, so that the ice cube tray is visible.
3. Pull the oval shaped fastener on the ice tray in the direction
of arrow 1.
Tilt the ice tray upward and pull it out in the direction of
arrow 2.
4. After cleaning the tray, put it back in, then firmly push in
the icemaker, close the freezer drawer, and switch on the
icemaker function via the display panel.

Icemaker usage precautions

Caution
For newly installed appliance, you should wait for 24 hours.
This will enable the freezer compartment to cool down, so that
it can make ice.
• The ice machine will make 8 ice cubes each time; but the
specific ice-making quantity will depend on the indoor
temperature, frequency that the doors are opened, water
pressure, freezer compartment temperature, etc.
• In order to ensure that the ice tray gets filled up with ice
cubes, the ice tray should be frequently pulled out so that the
ice cubes get evenly distributed.
• It is a normal phenomenon that some of the ice cubes will
clump together during removing (this can be resolved by
reducing the water intake times).
• When the freezer compartment reaches or is below -12 °C,
the icemaker will start making ice (if you are just beginning
to use the icemaker, or it has not been used to make ice in a
long time, you should discard the first several ice cubes, so
that impurities in the water line get run out.)
• The icemaker can just supply water via the reservoir on top
of the left hand door unit, it cannot be directly connect to
external drinking water source.
• The icemaker must be installed in the refrigerator through an
authorized service agency.
If you occasionally hear unusual sounds in
the refrigerator
You may occasionally hear some "crunching" sounds, but
these are just normal sounds that are emitted during ice
making, so do not worry.
If you do not often use ice cubes
"Old" ice cubes will become cloudy, and will not taste fresh;
therefore, please periodically clean the ice cube tray and
wash it out with warm water. Before replacing the ice cube
tray, be sure to cool it down, otherwise, ice will stick to other
parts of the ice machine and affect the ice making function.
If the icemaker in the freezer compartment
is not used for a long time
If not used for a long time, please remove the automatic
icemaker and any residual ice cubes in the ice storage
compartment, wash the ice cube tray and the ice storage
compartment with warm water, wipe them dry with a clean
towel and put them somewhere else in order to increase
storage space.
The water reservoir should be removed, any residual water
should be drained out and the tank should be cleaned with
warm water.
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents