Recording microphones, instrument microphone, headphones, wireless systems, multi-coupler, earphones, system architect plug in with sst 4 and sr 4000 stripes (12 pages)
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations. Changes or modifications not expressly approved in writing by AKG Acoustics may void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harm- ful interf e rence, and (2) this device must accept any interf e rence received, including interf e rence that may cause undesired operation.
4.1. Controls 1q ANTENNA A, ANTENNA B: BNC sockets for connecting the two supplied receiving antennas. The SR 61 and SR 81 4.1.1. Front Panel are diversity receivers and use two antennas in order to re- 1a POWER: Switches the power to the receiver ON and OFF. ceive the transmitter signal at two different spots.
W 23 foam windscreen for C 535 WL1 7. Frequencies Color Coding Kit The transmitter and receiver of your WMS 61 or WMS 81 system 6. Bodypack Transmitter have been factory programmed for up to 15 selectable carrier fre- quencies. The carrier frequency label (1k) on the receiver, (2g) on...
9. Setting Up If the status LED (2b) fails to illuminate the batteries are dead. Insert new batteries. Prior to connecting the receiver to AC power and inserting the bat- 4. Screw the supplied protective ring (2j) and the battery com- teries into the transmitter, set the transmitter and receiver to the partment cover back onto the transmitter CW.
9.5. Receiver BALANCED LINE/MIC switch (1p) to MIC. BALANCED socket (1o) - XLR cable - line input: set BALANCED 9.5.1. Placement LINE/MIC switch (1p) to LINE. Reflections off metal parts, walls, ceilings, etc. or the shadow UNBALANCED jack (1n) - 1/4” jack cable - unbalanced 1/4” effects of musicians and other people may weaken or cancel the microphone or line input jack.
LED (1g) lights, reposition the receiver and/or transmitter such that field strength will increase back to optimum (OK LED (1g) illuminating). 6. The MUTE LED (1f) on the receiver illuminating means the squelch is active. Remedies: Switch the transmitter ON or move closer to the receiver to the point that the MUTE LED (1f) will extinguish.
Need help?
Do you have a question about the WMS 61 and is the answer not in the manual?
Questions and answers