Furuno FR-8122 Installation Manual page 16

1. MOUNTING
• Connecting the signal cable
1. Open the antenna cover by loosening four bolts, and then fix the stay.
2. Unfasten the cable gland assembly (plate, gasket, flat washer). The plate is discarded.
3. Pass the signal cable with connector through the bottom of the antenna unit chassis.
Pass the cable through the gland assembly as shown below.
Passing the signal cable through the cable gland assembly
4. Fasten the gasket support with four bolts. Using one of the four bolts, fasten the
crimp-on lug on the shield wire.
1-8
Antenna unit chassis, cover opened
Gasket support
Gasket
Flat washer
Cable entry
RTB board cover
Cable entry