D-Link DCH-M225 Quick Installation Manual page 7

PRODUCT SETUP
SETUP
2. SET UP MUSIC EVERYWHERE USING Wi-Fi PROTECTED SETUP (WPS)
NOTE: In order to use the one touch WPS secure wireless connection, please make
sure that your home Wi-Fi router supports WPS and has the corresponding WPS
button.
3. SET UP MUSIC EVERYWHERE USING WEB CONFIGURATION
Music Everywhere can also be configured using the web configuration. After you have
plugged Music Everywhere into a wall outlet and the power LED is blinking amber,
go to wireless utility on your computer, select and connect to Music Everywhere's Wi-
Fi network and enter the Wi-Fi password (both can be found on the included Wi-Fi
Configuration Card and also on the device label). Then open a web browser and type
http://dlinkap.local. By default, the username is Admin, and the password field
should be left blank. Please refer to the product manual, which can be found on the
enclosed CD, for further information on configuring Music Everywhere using the web
GUI.
DCH-M225
Plug Music Everywhere into a wall outlet and wait until
the power LED is blinking amber. Push the WPS button
on your home Wi-Fi router (please refer to your home
Wi-Fi router's manual if necessary) and then push the
WPS button on Music Everywhere within 120 seconds.
The LED will start to flash green.
Please allow up to two minutes for the process to finish.
The LED will turn solid green when Music Everywhere
has connected successfully to your home Wi-Fi network.
Music Everywhere is now ready for you to wirelessly
stream music to your speakers as well as extending
your existing Wi-Fi network. If you are connecting to the
extended wireless network that was set up using WPS,
the extended SSID will have the extension "-EXT" added
to the original SSID and the password will be same as
your existing wireless password.
7