Bosch PSR 9,6 VE-2 Operating Instructions Manual page 10

2 609 932 287 - Buch Seite 2 Mittwoch, 22. Oktober 2003 1:58 13
Convince yourself before using that the battery
is securely seated in the machine.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage.
Hold the machine tightly: When driving in
screws, high reaction moments can briefly oc-
cur.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
Battery and Battery Charger
The enclosed operating instructions for the
battery charger must be read carefully!
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion! Do not place the battery on radi-
ators or expose to strong sun rays for a longer
time; temperatures over 50 °C cause damage.
Do not dispose of the battery in household
waste or discard into fire or water.
Before Putting into Operation
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging /discharging
cycles.
To remove the battery 7, press the unlocking but-
tons 8 and pull out the battery downwards. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
10 • 2 609 932 287 • 03.10
Changing the Tool
Open the drill chuck 3 by turning until the tool can
be inserted. Insert the tool.
Firmly tighten the sleeve of the keyless chuck 3
by hand. This automatically locks the chuck.
Rotate the sleeve in the reverse direction to re-
move the tool.
Screwdriving (see figure
Directly clamp the screwdriver bit 6 into the drill
chuck or use the additional universal bit holder 12
when operating with hex shank bits 11.
Initial Operation
Inserting the Battery
Set the rotational direction switch 5 to the centre
position = lock-off and allow the charged bat-
tery 7 to engage into the handle.
Switching On and Off
To start the machine, press the On/Off switch 4
and keep it depressed.
The machine runs with variable
speed between 0 and maximum,
depending on the pressure applied
to the On/Off switch 4. Light pres-
sure results in a low rotational
speed thus allowing smooth, con-
trolled starts. Do not strain the ma-
chine so heavily that it comes to a
standstill.
To switch off the machine, release the On/Off
switch 4.
Gear Selection, Mechanical
Two speed ranges can be preselected with the
gear selector 1:
1st gear: Low rotational speed, high power.
2nd gear: High rotational speed, less power.
The speed settings may only be changed when
the machine is motionless. If the speed setting
has not quite notched in properly, briefly press
the On/Off switch 4.
English - 2
)
A