Replacing The Lamp; Closing The Door - Zanussi ZRB33104WA User Manual

Problem
Water flows on the rear plate of
the refrigerator.
Water flows inside the refrigera-
tor.
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
www.zanussi.com
Possible cause
Temperature is set incorrectly.
During the automatic defrost-
ing process, frost melts on the
rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.

Replacing the lamp

1. At the same time, with the fingers expand
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
up and down the transparent cover and
unhook it in the direction of the arrows.
Solution
23