Kenwood TS-2000 Instruction Manual page 20

4 GETTING ACQUAINTED
PF
F LOCK A
$4 RIT/SUB control
After switching the RIT or XIT function ON, turn this
control to select the desired frequency offset {pages
38, 40}.
Turn to adjust the sub-receiver frequency when the
RIT and XIT functions are switched OFF and the sub-
receiver is switched ON {page 45}.
$5 MANUAL BC control
Turn to adjust the audio notch frequency while the
DSP beat cancel function is set to manual audio
notch filter mode {page 56}.
$6 MAIN RF GAIN control
Turn to adjust the radio frequency gain for the main
transceiver {page 18}.
$7 MULTI/ CH control
In VFO mode, rotate to step the operating frequency
up or down {page 37}. In memory channel mode,
rotate to select a memory channel {page 58}. Also
used for selecting Menu numbers when accessing the
Menu mode {page 21} and as a selector to choose
settings for various functions activated by front panel
buttons. The MULTI/ CH LED lights when the
setting(s) can be changed using the MULTI/ CH
control.
$8 MAIN SQL control
Used for muting ("squelching") the speaker, head
phone and AF output on ACC2 (13-pin DIN
connector) when no receive signal is present on the
main transceiver {page 19}.
$9 MAIN AF control
Turn to adjust the volume on the main transceiver
{page 19}.
%0 SUB SQL control
Used for muting ("squelching") the speaker, head
phone and AF output on ACC2 (13-pin DIN
connector) when no receive signal is present on the
sub-receiver {page 46}.
12
54
MAIN
AUTO
CAR
LSB
USB
MIC
REV
TX MONI
CW
PWR
FSK
DELAY
NAR
FM
KEY
AM
CLR
SEL
DISP 1MHz
52 53
55
HF/VHF/UHF ALL MODE MULTI BANDER TS-2000
SUB
MENU
TF-
SET
MAIN SUB
SG.SEL
CTRL SCAN M.IN
M VFO
48
%1 SUB AF control
Press to switch the sub-receiver ON or OFF. When it
is ON, the SUB-receiver LED lights orange.
Turn to adjust the volume for the sub-receiver.
%2 LO/ WIDTH control
Turn clockwise/ counterclockwise to increase/
decrease the value for the low cut-off DSP filter
frequency or the filter bandwidth (CW/ FSK). The
selected value appears on the main dot-matrix
display {page 55}.
%3 HI/ SHIFT control
Turn clockwise/ counterclockwise to increase/
decrease the value for the high cut-off DSP filter
frequency or the Shift frequency. The selected value
appears on the sub dot-matrix display
{page 55}.
%4 MAIN band LED
Lights green while the main transceiver's squelch is
open. Lights red while transmitting on the main
transceiver's VFO band.
%5 SUB band LED
Lights green while the sub-receiver's squelch is open.
Lights red while transmitting on the sub-receiver's
VFO band.
45 46 44 47
CW TUNE 9.6k STA CON
RIT
RIT/SUB
ALT
XIT
_
+
CLEAR
P.C.T
SET
49 50 51