Shark SC660 Series Owner's Manual page 9

IMPORTANT: Once plugged in, the Blue LED will
illuminate, and your portable steam cleaner cleaning
system will be ready to use within 30-45 seconds.
(fig. 4)
WARNING: Your portable steam cleaner is designed
to clean surfaces that will withstand high heat and
moisture. Do not use on unsealed wood surfaces
(especially wooden antique furniture), unglazed
ceramic tile, or surfaces that have been treated
with wax, oils, varnishes, or shellac. The sheen
may be removed by the heat, steam, and friction
of the cleaning tools. Lacquer and polyurethane
coatings provide a hard durable protective finish that
withstands moisture but it is always recommended
to test an isolated area of the surface to be cleaned
before proceeding.
We also recommend you check the use and care
instructions from the surface manufacturer.
NOTE: Make sure surfaces are free of crumbs and
debris before using the portable steam cleaner.
fig. 4
GENERATING STEAM
1
Plug the unit in and wait about 30 to 45 seconds
then press and hold the steam trigger to activate the
pump. You will immediately hear steam generating
and begin to see visible results either from the nozzle
or the attached cleaning tool. It is recommended
that you wait at least 30 seconds before pulling the
trigger as this will minimise water spitting. (fig. 5)
2
Once you release the steam trigger, the pump will
stop delivering water to the boiler and the steam will
reduce to a stop when the boiler becomes empty.
CAUTION: Steam is hot and can cause burns, so
please use with caution.
www.sharkninjamanuals.com
fig. 5
8