Shark SC660 Series Owner's Manual page 12

Using Your Portable Steam Cleaner with Wedge Cleaning Tool
Cleaning Tip: The wedge cleaning tool with the wedge tip and squared edges can reach into tight areas often missed
or difficult to reach with traditional cleaning methods. The wedge sides concave to wrap around sink and faucet fixtures,
door knobs, and other small curved surfaces leaving them clean all around. The wedge cleaning pocket was designed
for cleaning a variety of surfaces and is exceptional on those surfaces that are large and flat, both horizontal and vertical.
Broad cleaning sides and super absorbent fabrics loosen, lift, and lock in dirt and grime while sanitising at the same
time.
1
Slide the wedge shaped cleaning pocket over the
wedge cleaning tool frame until it is completely on.
Secure the cleaning pocket onto the frame. Close
the cinch pocket onto the frame by pulling on the
elastic band and sliding the locking bean to tighten.
(fig. 14, fig. 15)
2
Attach the Wedge Cleaning Tool by snapping into
the handle of the Accessory Hose. (fig. 16)
11 1-800-798-7398
fig. 14
fig. 16
3
4
Press and hold the steam trigger to create steam.
To remove the Wedge Cleaning Tool, press and hold
down the Accessory release button. Then slide out
the Wedge Cleaning Tool.
CAUTION: Do not press steam trigger while
attaching or removing the Wedge Cleaning Tool.
Always use the Wedge Cleaning Tool with the pocket
attached.
fig. 15