Table of Contents
Advertisement
Service Manual
Model No.: HL22F2a
Battery loading
1. Slide open the cover of the battery compartment on
the back of the remote controller.
2. Load two 7# (AAA) alkaline batteries in the
compartment, (plus and minus poles to respective mark)
3. Replace the cover of the battery compartment.
Precautions
As strong light may interfere the signals, change your
position to operate the remote controller if the television
cannot be turned on or off as you expect.
Keep the remote controller away from heat source
or humid area to ensure effective performance of the
remote controller.
Remote control
The remote control cannot be operated unless the batteries are properly loaded.
When using the remote control, aim it at the remote sensor on the TV.
PICTURE
1
ARC
CCD
MTS/SAP
2
3
INPUT
4
MENU
5
CH+
6
VOL-
VOL+
ENTER
CH-
EXIT
7
USB
PLAY/PAUSE
STOP
8
9
REV
PREV
10
11
DISPLAY
GUIDE
FAVORITE
12
13
(For TV without DVD)
Color buttons
Red
Green
Yellow
UP
DOWN LEFT
When functions are attached to the
color buttons, the color buttons are
shown on screen.
24
1 PICTURE
14
AUDIO
2 ARC
15
3 CCD (closed caption)
SLEEP
16
4 INPUT
17
5 MENU
Thumbstick (Up/Down/
6
Left/Right)
18
7 EXIT
8 USB
19
9 USB PLAY/PAUSE
MUTE
20
0 USB fast reverse
A USB fast forward
21
B DISPLAY
C GUIDE
D Power
RECALL
22
E AUDIO
REPEAT
23
F SLEEP button
24
NEXT
G MTS/SAP
25
CH.LIST
26
H Number buttons
27
28
I
J MUTE
K ENTER
L RECALL
M USB REPEAT
N USB STOP
Blue
O USB Next Chapter
RIGHT
P USB Previous Chapter
Q CH.LIST
R FAVORITE
Make sure that two AAA alkaline batteries are loaded.
The batteries must be of the same type. The batteries
must be located properly. The batteries are not
rechargeable.
Make sure that there is no obstacle between the remote
controller and television set.
Press repeatedly to cycle through the available picture modes
Select the aspect ratio
Select a closed caption option
Show the input source
Press to open the on-screen menu
Volume/Channel Selection, Allows you to navigate the on-screen
menus and adjust the system settings to your preference.
Clears all on-screen displays and returns to TV viewing from any
menu
Press to switch input source to USB in
Press to display the TV status information on the top of the TV screen
Display the guide when you are watching analog or digital channels
Press to turn on and off the TV
Press to cycle through different sound settings
Press to display the sleep timer option
Select MONO, STEREO, SAP in NTSC system
Press to change a channel
Press to select digital channels. For example, to enter "54-3",
Switches the sound on or off
Accesses the highlighted item in the on-screen menu
Press to jump back and forth between two channels
Open the channel list in TV
Open the favourite channel list in TV
Advertisement
Table of Contents
