Table of Contents
Advertisement
Connection Option 1
Set VCR output switch to channel 3 or 4 and then tune
the TV to the same channel number.
Connection Option 2
A
Connect the audio and video cables from the VCR's
output jacks to the TV input jacks, as shown in the
figure. When connecting the TV to VCR, match the
jack colors (Video = yellow, Audio Left = white, and
Audio Right = red). If you connect a S-VIDEO output
from VCR to the S-VIDEO input, the picture quality is
improved; compared to connecting a regular VCR to
the Video input.
B
Insert a video tape into the VCR and press
the VCR. (Refer to the VCR owner's manual.)
C
Select the input source with using the
on the remote control, and then press
to select the source, press ENTER button to confirm.
A/V Source Setup
A
Connect the audio and video cables from the
external equipment's output jacks to the TV input
jacks, as shown in the figure.
B
When connecting the TV to external equipment,
white, and Audio Right = red).
VIDEO
L -AUDIO- R
How to use
A
Select the input source with using the
on the remote control.
B
Operate the corresponding external equipment.
Refer to external equipment operating guide.
Component Setup
How to connect
A
Connect the DVD video outputs (COMPONENT) to
the Y Pb Pr jacks on the TV and connect the DVD
audio outputs to the YPbPr Audio IN jacks on the TV,
as shown in the figure.
B
If your DVD only has an S-VIDEO output jack, connect
this to the S-VIDEO input on the TV, as shown in the
figure.
PLAY on
INPUT button
/
button
L
R
INPUT
Note
If your DVD player does not have
component video output, use S-Video.
Y
Pb
How to use
A
Turn on the DVD player, insert a DVD disc.
B
Use
INPUT button on the remote control to select
proper input.
Connecting a computer
How to connect
A
To get the best picture quality, adjust the VGA
graphics card to 1024 768.
B
Use the TV's VGA or DVI (Digital Visual Interface)
Audio IN port for audio connections, depending on
your computer connector.
If the graphic card on the computer does not
output analog and digital RGB simultaneously,
connect only one of either VGA IN or HDMI IN to
display the VGA on the TV.
If the graphic card on the computer does output
analog and digital RGB simultaneously, set the TV
to either VGA or HDMI; (the other mode is set to
Plug and Play automatically by the TV.)
C
Then, make the corresponding audio connection.
If using a sound card, adjust the VGA sound as
required.
PC/DVI AUDIO IN
PC IN
Service Manual
Model No.: HL22F2a
Pr
L -AUDIO- R
19
Advertisement
Table of Contents
