Electrical Adjustment; Service Adjustment Menu Operation - Sanyo PLV-Z1X Service Manual

■ Electrical Adjustment

● Service Adjustment Menu Operation
◆ To enter service mode
To enter service mode, press and hold the "MENU" and
"INPUT" buttons on the projector simultaneously for 5 sec-
onds. The "S" mark appears on the screen. While the "S"
mark is displayed on the screen, press and hold the "
POINT UP"and "POINT DOWN" buttons on the projector
or "SCREEN" button on the remote control unit for more
than 3 seconds. As shown in a figure, a service mode dis-
play appears on a screen.
◆ To adjust service data
Adjust service data using the following control buttons.
– "POINT UP" ................An item number increases.
– "POINT DOWN" ..........An item number decreases.
– "POINT RIGHT" ..........An adjustment value increases.
– "POINT LEFT" ............An adjustment value decreases.
◆ To exit service mode
To quit the service mode, press the "POWER ON/OFF"
button only once on the projector or the remote control
unit .
MENU
Normal Mode
+
INPUT
Service Mode
Input mode Video
Item No.
Version
TempA
Fan1 Speed Fan2 Speed Fan3 Speed Fan4 Speed
"S" mark display
S
Normal Dynamic
108 0
100 SANYO
TempB TempC
27 38 39
80 65 85
UP
Service mode
+
DOWN Service Mode
POWER
ON-OFF
Screen mode
Image mode
Data
Brand
60
-23-
Top Control
ON-OFF
POWER
WARNING
LAMP
REPLACE
MENU INPUT
SELECT
Remote Control
LL
LIGHT
RESET
CANCEL
MENU
SELECT
SCREEN
IMAGE ADJ.