Nokia COMMUNICATOR 9210I Network Setup page 3

1. INTRODUCTION
To obtain access to WAP services
you must be within the coverage of a network which supports data calls,
a data service must be activated for your SIM card,
you must have obtained a WAP access point from a WAP service provider, and
you must have entered the proper WAP settings.
Before you can use the WAP services, you need to configure your WAP settings. Your WAP
service provider will provide you with the exact values for the WAP settings. Follow the
instructions carefully. You can use this information to define and edit the settings manually.
Also, your service provider may be able to send some, or all, of the required settings to you
via a special short message called an Over The Air (OTA) message. After you have received
the settings, you can start using the WAP application or edit the settings as described below.
Note: The necessary settings for WAP configuration are provided by your WAP
Service Provider. Depending on your service provider, you may not need to fill in
all of the settings
2. WAP ACCESS POINTS
2.1 DEFINING WAP ACCESS POINTS
To set up a new WAP access point, open Internet startup under the Extras application, and
select WAP access (a shortcut to Internet startup can also be found in the Desk application).
1/2