Hitachi CG 25EUS Safety Instructions And Instruction Manual page 7

Throttle wire/stop cord
Remove air cleaner cover. (Fig. 3)
Connect stop cords. (Fig. 4)
Connect throttle wire end to carburetor and install
swivel cap (4) (if so equipped) where is included in
tool bag, onto swivel. (Fig. 5)
Attach the air cleaner cover.
Installation of blade guard (Fig. 6)
Install the blade guard as shown in Fig. 6.
Fig. 3
Fig. 4
4
Fig. 5
Fig. 6
NOTE
If your unit has guard location label on drive shaft
tube, follow the indication.
CAUTION
● Some blade guards are equipped with sharp
line limiters. Be careful with handling it.
Installation of semi-auto cutting head
1. Function
Automatically feeds more nylon cutting line when
it is tapped at low rpm (not greater than 4,500
rpm).
Specifi cations
Type of
Code
attaching
No.
screw
Female
6696454
screw
Applicable nylon cord
Cord diameter: 0.12 in. (Φ3.0 mm)
Length: 6.56 ft. (2 m)
Cord diameter: 0.10 in. (Φ2.4 mm)
Length: 13.12 ft. (4 m)
2. Precautions
○ The case must be securely attached to the cover.
○ Check the cover, case and other components for
cracks or other damage.
○ Check the case and button for wear.
If the wear limit mark on the case is no longer
visible or there is a hole in the bottom of the button,
change the new parts immediately. (Fig. 7)
○ The cutting head must be securely mounted to the
unit's gear case.
○ For outstanding performance and reliability,
always use Hitachi nylon cutting line. Never
use wire or other materials that could become a
dangerous projectile.
5
○ If the cutting head does not feed cutting line
properly, check that the nylon line and all
components are properly installed. Contact your
Hitachi dealer if you need assistance.
English
Size of
Direction of
attaching
rotation
screw
M10×
Counterclockwise
P1.25-LH
6
Fig. 7
7