Advertisement
THE POSSIBLE PROBLEMS AND SOLUTIONS
Phenomenons
Motor does not run
Can not fly straight
Can not climb
Limited control range
Problems
1. Battery is not fully charged.
2. The circuit in model has been
damaged due to Cra sh.
1. The rudder is not on the
center position.
2. The main wing has not been
installed on the fuselage center
1. The battery is not fully charged.
2. The elevator declines downward.
1. The batteries are almost flat
2. The transmitter aerial is not fully
extended
Solutions
1. Charge the battery.
2. Install new dry cells.
3. Contact the distributor.
4. Reassembly
1. Adjust the trim on the
transmitter.
2. Reinstall the main wing.
1. Charge the battery
2. Adjust the trim on the
Transmitter.
1. Install new batteries
2. Fully extend the transmitter
aerial
10 GETTING STARTED WITH THE TRANSMITTER
Please note:
:::;;;:,,;:;:; In the operating Instructions, the numbers in the text always refer to the
figure opposite or the figures within the section. Cross references to other
figures are indicated with the respective figure number.
a) Inserting the Batteries/Rechargeable Batteries
For the power supply of the transmitter you will need eight mignon alkaline batteries
or rechargeable batteries (AA). For ecological and also economical reasons, it is recommended
to use rechargeable batteries, since they can be recharged in the transmitter via a
built-in charging socket. To insert the batteries or rechargeable batteries, procedures
are as follows.
The battery compartment lid(1) Is located on
the rear side of the transmitter. Please press the
corrugated triangle and push off the lid downward.
Now insert the eight batteries or rechargeable
batteries in the battery compartment. Observe
the correct polarity of the individual cells. A
corresponding note(3) is located on the bottom
of the battery compartment.
A f t e r w a r d s , slide the lid of the b a t t e r y
compartment back on from the bottom and let
the locking mechanism click into place.
Either a teacher/student cable with a 3. 5mm jack connector or an interface
cable for flight simulator can be connected can be connected to the student
socket.
Advertisement
