Advertisement
23. Trace the wires from the elevator and
nose wheel steering servos and plug them
into the appropriate positions on you
receiver.
24. If you are going to control both aileron
servos from a single channel on the receiver,
plug the supplied "Y" connector into the
Aileron channel on receiver. See Photo.
25. Photo of Ailerons connected to a single
channel "Y" connector.
26. P h o t o s h o w 2 a i l e r o n s c o n t r o l l e d by
individual channels on the receiver. This
requires the addition of 2 short aileron
extensions (not included).
27. S e p a r a t e aileron channels allows the
p r o g r a m m i n g o f a i l e r o n d i f f e r e n t i a l
f o r s m o o t h e r turn p e r f o r m a n c e with
less adverse yaw.
28. Position wing in wing saddle.
~[sr
29. Screw in place with supplied screws.
30. Epoxy Velcro strap in battery box.
31. After epoxy has set, install lipo battery
per photo.
32. Close Velcro to hold battery in position.
i
T
Advertisement
