Manually Adjusting The Shutter Speed - Panasonic AW-HE60HN Operating Instructions Manual

Manual shooting
● ■
Manually adjusting the shutter
speed
The shutter speed can be set using two methods. One is
a method that specifies the time (where a time such as
1/250 sec. is designated), and the other is a method that
specifies the frequency (where synchro scan, 60.24 Hz*, etc.
is designated).
When shooting a TV screen or PC monitor screen, the
horizontal noise generated when the screen is shot can
be minimized by adjusting the frequency to the screen
frequency using synchro scan.
*: This describes when 59.94 Hz has been set as the unit's
frequency.
When performing the operations
using the wireless remote control
Perform the adjustments on the Camera menu.
For further details, refer to the [Shutter Mode] and
[Step/Synchro] items on page 42.
When performing the operations using the controller
Note
● ● When the following settings are made on the
AW-HE60, the shutter speed cannot be manually
adjusted (as the camera is locked in auto mode).
● ● Shooting mode (Scene) is in [FullAuto]
(For details, refer to pages 10 to 12.)
● ● Contrast Mode is in [Auto]
(For details, refer to pages 42 and 72.)
When the AW‑RP655 is connected:
These operations can be performed in the same procedures
as "When performing the operations using the wireless
remote control" by following the operation steps in "Basic
operations" (pages 32 to 39).
When the AW‑RP555 is connected:
1
Press the [SHUTTER] button and turn its lamp
on.
The shutter speed set ahead of time is selected.
2
If necessary, press the [SHUTTER] button to
turn its lamp off in order to return the shutter to
the OFF setting.
18
(continued)
● ●
How to set the shutter speed using the AW‑RP555
1
With the [MEMORY] button held down, press
the [SHUTTER] button.
The [1] to [5] and [6] to [10] buttons of [PRESET] blink
alternately.
2
Press one of the [1] to [8] buttons or the [10]
buttons of [PRESET] — whichever button
corresponds to the shutter speed which is to
be set.
Any of the shutter speeds in the table below can be set.
[When 59.94 Hz has been set as the unit's frequency]
[1] [2]
1/100 1/250
[6] [7]
1/4000 1/10000
[When 50 Hz has been set as the unit's frequency]
[1] [2]
1/120 1/250
[6] [7]
1/4000 1/10000
● ● Any change in the shutter speed is reflected the next
time the [SHUTTER] button is pressed and its lamp is
turned on.
● ● When OFF is selected, the shutter will not operate
even when the [SHUTTER] button is pressed.
● ● Select the synchro scan setting on the menu.
● ● The shutter speed setting performed here is stored in
the memory even when the power of the AW-RP555
is turned off.
For further details, refer to the Operating Instructions of the
AW-RP555.
When the AW‑RP50 is connected:
For details, refer to the operating instructions supplied with
the controller.
[3] [4] [5]
1/500 1/1000 1/2000
[8] [10]
Synchro Scan OFF
[3] [4] [5]
1/500 1/1000 1/2000
[8] [10]
Synchro Scan OFF