Remote Control - TomTom GO 730 User Manual

Remote control
Important: This TomTom product is Bluetooth
enabled. Please note that in certain
environments, such as hospitals or airplanes,
you are required to switch off Bluetooth on all
electronic devices.
Inserting the batteries
1. Hold the sides of the remote control and
press the latch on the back of the device.
Note: If you do not use your remote control for 20
seconds, it goes into power saving mode.
If you do not use your remote control for one hour,
the remote control switches off completely.
Press any button to switch your remote control on.
Establishing a connection
Before your remote control can communicate
with your TomTom GO, you need to establish
a Bluetooth connection between your remote
control and your GO. This Bluetooth process is
also known as 'pairing'.
The first time you switch on your remote
control, it tries to establish a connection with
the nearest GO.
To establish a connection, do the following:
1. Switch on your TomTom GO and tap
Bluetooth preferences in the Preferences
menu.
The keypad lifts out from the back of the
device, as shown in the diagram. Take care
not to drop the keypad.
2. Place the batteries in the remote control.
Make sure you put the batteries in the
correct way round, as shown on the remote
control.
3. Replace the battery cover and press any
button to switch on your remote control.
Your remote control starts searching for
your TomTom GO.
o
Bluetooth
preferences
Note: This button may only be
available if all menu options are
shown. To show all menu
options, tap Show ALL menu
options in the Preferences
Menu.
14
2. Tap Enable Bluetooth.