Driver Installation Guide - ASROCK 970 Extreme3 Quick Installation Manual

HDMI_SPDIF Header
(2-pin HDMI_SPDIF1)
(
see p.2 No. 31)

2.10 Driver Installation Guide

To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom side
to install those required drivers. Therefore, the drivers you install can work properly.
2.11 Installing Windows
XP 64-bit With RAID Functions
If you want to install Windows
bit on your SATA3 HDDs with RAID functions, please refer to the document at the
following path in the Support CD for detailed procedures:
..\ RAID Installation Guide
2.12 Installing Windows
XP 64-bit Without RAID Functions
If you want to install Windows
OS on your SATA3 HDDs without RAID functions, please follow below procedures
according to the OS you install.
2.12.1 Installing Windows
If you want to install Windows
functions, please follow below steps.
Using SATA3 HDDs without NCQ and Hot Plug functions (IDE mode)
STEP 1: Set up UEFI.
A. Enter UEFI SETUP UTILITY
B. Set the "SATA Mode" option to [IDE].
STEP 2: Install Windows
26
®
7 / 7 64-bit / Vista
®
7 / 7 64-bit / Vista
®
7 / 7 64-bit / Vista
®
7 / 7 64-bit / Vista
®
XP / XP 64-bit Without RAID Functions
®
XP / XP 64-bit on your SATA3 HDDs without RAID
Advanced screen
®
XP / XP 64-bit OS on your system.
ASRock 970 Extreme3 Motherboard
HDMI_SPDIF header, providing
SPDIF audio output to HDMI
VGA card, allows the system to
connect HDMI Digital TV/
projector/LCD devices. Please
connect the HDMI_SPDIF
connector of HDMI VGA card to
this header.
TM TM
/ Vista 64-bit / XP /
TM TM
/ Vista 64-bit / XP / XP 64-
TM TM
/ Vista 64-bit / XP /
TM TM
/ Vista 64-bit / XP / XP 64-bit
Storage Configuration.