Battery Removal; Battery Installation; Battery Storage - Polaris 600 IQ LXT Owner's Manual

MAINTENANCE
Battery
WARNING! Improperly connecting or disconnecting battery cables can result in
an explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the battery,
always connect the negative (black) cable last.

Battery Removal

1. Open the hood and remove the left side panel to access the battery.
2. Disconnect the black (negative) battery cable first.
3. Disconnect the red (positive) battery cable last.
4. Remove the battery.

Battery Installation

When installing a new battery, make sure it's fully charged prior to its
initial use. Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can also hinder vehicle
performance. Follow the battery charging instructions on page 117
before installing the battery.
1. Ensure that the battery is fully charged.
2. Set the battery in the battery holder.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Verify that cables are properly routed.
6. Reinstall the side panel.

Battery Storage

Whenever the vehicle is not used for a period of three months or more,
remove the battery from the vehicle, ensure that it's fully charged, and
store it out of the sun in a cool, dry place. Check battery voltage each
month during storage and recharge as needed to maintain a full charge.
Tip: Battery charge can be maintained by using a POLARIS Battery Tender
charger or by charging about once a month to make up for normal self-
discharge. Battery Tender
period, and will automatically charge the battery if the voltage drops below a
pre-determined point.
116
TM
can be left connected during the storage
TM