Troubleshooting Drives - Dell Precision 420 User Manual

1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from their electrical outlets. Also, disconnect
any telephone or telecommunication lines from the computer.
CAUTION: Before you remove the computer cover, see
2. Remove the computer cover.
3. If you have a mini tower chassis, remove the AGP card brace according to the instructions in
Brace."
4. Install a jumper plug on the
5. Replace the computer cover, reconnect the system to an electrical outlet, and turn it on. If the problem is not resolved, see
instructions on obtaining technical assistance.

Troubleshooting Drives

NOTE: Dell Precision WorkStation 420 systems are equipped with
problems. Make note of any LED codes you observe before contacting Dell for technical assistance.
If the monitor displays a system error message to indicate a drive problem during execution of either the boot routine or the
a drive is not operating correctly, perform the following steps:
1. Enter System Setup and verify that the problem drive is configured correctly. Make any necessary changes, and reboot the system.
2. If the problem is not resolved, turn off the system, including any attached peripherals, and disconnect all the AC power cables from their
electrical outlets. Also, disconnect any telephone or telecommunication lines from the computer.
CAUTION: Before you remove the computer cover, see
3. Remove the cover from your
4. Verify that the DC power cables from the power supply are firmly connected to the connectors on each drive. Also verify that the interface
cable for each drive is firmly connected to the drive and to the system board.
5. Replace the computer cover on your
on. If the problem is not resolved, proceed to step 6.
6. Insert the Dell Precision ResourceCD into the CD-ROM drive, reboot the system, and run the appropriate test group in the
If the Dell Diagnostics identifies a faulty drive, replace the drive. If the Dell Diagnostics identifies a faulty controller, the system board may be
faulty. See "Getting Help" for instructions on obtaining technical assistance.
Back to Contents Page
RTCRST jumper pins and then remove it.
desktop chassis or from your
desktop chassis or on your
"Safety First—For You and Your
diagnostic LEDs to help provide information about possible
"Safety First—For You and Your
mini tower chassis.
mini tower chassis, reconnect the system to an electrical outlet, and turn it
Computer."
"Removing and Replacing the AGP Card
"Getting
Dell Diagnostics, or if
Computer."
Dell
Help" for
Diagnostics.