Polaris Ranger 4x4 500 EFI Owner's Manual page 36

Break-In Period
Engine and Drivetrain Break-in
1. Fill the fuel tank with gasoline. Heed the gasoline warnings on page
21.
2. Check the oil level. See page 61. Add the recommended oil as
needed to maintain the oil level in the normal (safe) operating
range.
3. Drive slowly at first. Select an open area that allows room to famil-
iarize yourself with vehicle operation and handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 34.
6. Pull only light loads.
7. During the break-in period, change both the oil and the filter at 25
hours.
8. Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable ten-
sion. See page 86.
PVT Break-in (Clutches/Belt)
A proper break-in of the clutches and drive belt will ensure a longer life
and better performance. Break in the clutches and belt by operating at
slower speeds during the break-in period as recommended. Pull only
light loads. Avoid aggressive acceleration and high speed operation dur-
ing the break-in period.
OPERATION
33