Step 14. Level Doors; Step 15 Remove Packaging Start Icemaker; Step 16 Temperature Controls - Monogram ZISS480DHSS Installation Insrtuctions

STEP 14 LEVEL THE DOORS
Remember a level refrigerator is necessary for
getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
When
the left
door is
lower than
the right
door.
If you open the freezer door, you can see the
A.
center hinge.
B. Insert 1/4" Allen wrench into the shaft of the
center hinge.
C. Adjust the height by turning clockwise
or counterclockwise. When you turn
counterclockwise, the door will move up.
Installation Instructions
When
the left
door is
higher
than
the right
door.
Adjustment
point
RAISE
13
STEP 15 REMOVE PACKAGING
START ICEMAKER
Power Switch
Feeler Arm
A. Remove all tape, foam and protective packing from
shelves and drawers.
B. Remove the tie downs from the freezer baskets.
Set the icemaker power switch to the I (on) position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It will
then begin operation automatically. It will take 2–3 days
to fill the ice bin.
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver enough water
to the icemaker.

STEP 16 TEMPERATURE CONTROLS

• The temperature controls are preset at 37°F
for the refrigerator and 0°F for the freezer.
• Allow 24 hours to stabilize before making adjustments.