NEC AccuSync LCD22WMGX User Manual page 10

OSD Setup
H. Position
Adjusts the horizontal position of the OSD.
V. Position
Adjusts the vertical position of the OSD.
Timeout
Adjusts the OSD timeout.
Language
Sets OSD display language to English.
(English is the default setting).
Extra
Input Select
Selects input source Ypbpr and HDMI for MFM.
Auto Adjust
Auto Adjusts the H/V Position, Focus and Clock of picture.
DDC/CI
Turns on or off the two-way communication between the
graphics card and the monitor.
With DDC/CI turned on, some monitor settings
can be adjusted through the graphics card using
a computer.
Reset
Clears each old status of Auto-configuration and sets the
color temperature to Warm and recall.
Aspect
Sets up the rate of showing.
Information
Shows the resolution, H/V frequency, serial number and input
port of current input timing.
01_English
OSD Message:
Auto Config Please Wait
1. When Analog signal input, if User Press Hot-Key "Auto", will show
this message, and the monitor do the auto configuration function.
This message location is at the position setting in "OSD Setup"
item.
2. When Digital signal input, without this OSD Message.
Input Not Support
When the Hsync Frequency, Vsync Frequency or Resolution is out of
the monitor support range, will show this message. This message will
be flying.
No Signal
When the video cable is not connected, or the video cable is
connected but there is no active signal input, will show this message,
after 9s the monitor will enter power saving. This message location is
at the position setting in "OSD Setup" item.
OSD Locked
When the OSD is unlocked, keep holding down "Menu" key and
"Power" key once to turn on the monitor, the OSD will be locked and
show this message. When the OSD is locked, only Power key
function is still working, if user press other key will also this message.
When the OSD is locked, keep holding down "Menu" key and press
"Power" key once to turn on the monitor, the OSD will be unlocked an
does not show message. This message location is at the position
setting in "OSD Setup" item.
Input Signal
1. D-SUB: Analog PC source is selected.
2. DVI: Digital PC source is selected.
3. Ypbpr: Analog Video source (Component) is selected.
4. HDMI: Digital Video source (HDMI) is selected.
English-6
6 25/9/07, 12:15 PM