Cabinet (Rear) Section; Discharging The Capacitor - Sony MVC-CD500 Service Manual

2-6. CABINET (REAR) SECTION

9 Harness (2P)
3 Two ES lock screws
(M2 × 4)

2-7. DISCHARGING THE CAPACITOR

Caution
4 Discharging the capacitor
Caution
Note: The power supply capacitor of the flash unit is charged to the high tension
voltage as high as 300 V at a maximum. You will get electrical shock when
you touch the terminal of the charged capacitor . The charged potential
remains even after the main power of the machine is turned off. Discharge
the remaining power in the capacitor referring to Service Note
(See page 1-1). High-voltage cautions. Short jig (R: 1k Ω /1W)
6 Remove the cabinet (rear)
section in the direction of the arrow.
8 Hot shoe (10P)
(from the microphone)
4 ES lock screw
(M2 × 4)
1 Tapping screw
(M1.7 × 5)
Tape (A)
Capacitor
3 Tape (A)
Capacitor
A
B
7 Harness SS-089 (8P)
(from the flash unit)
2 FP-763 flexible board (51P)
(from the CD-439 board)
1 FP-685 flexible board (18P)
(from the CD-439 board)
- 4 3
C D
2 Turn over the capacitor retainer
in the direction of the arrow.
2-5
MVC-CD500
A B
S Y
- 0 8
6
0 Cabinet (rear)
section
5 Open the battery lid.
9