5-5. Cleaning Or Replacing GA16C2 Gun Liner
3/8 in
Remove nozzle,
contact tip, and
liner collet.
Gun/feeder
connector
Tools Needed:
3/8 in
Turn off welding power
source/wire feeder.
3/8 in
Blow out
gun casing.
Remove liner
To Reassemble Gun:
Install contact tip.
Insert new liner.
Install collet onto liner and tighten
into gun/feeder connector using
wrench.
Cut liner off near collet so that liner
end is as close to drive rolls as
possible without touching.
Install nozzle.
Ref. ST-801 979
OM-210 089 Page 23