Samsung HT-E6750W User Manual page 33

Wired - Manual
❏
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1 . Select Start in the Network Settings screen,
and then press the v button. The Network
Status screen appears. The product attempts
to verify the network connection and fails.
Network Settings
Wireless network disconnected
MAC Address XX:XX:XX:XX:XX:XX
IP Address
Subnet Mask
Gateway
DNS Server
Unable to connect to wireless router. Try the following: check
that the router is turned on, and if it is, try turning it off and on
again. Check if you need to enter a security key to use the router.
2 . Select IP Settings on the right of the screen,
and then press v button.
The IP Settings screen appears.
3 . Select the IP Mode field, and then set it to
Manual.
4 . Use the number keypad on your remote to
enter the Network values. Use the ▲▼◄►
buttons on the remote to move from entry
field to entry field.
| NOTE |
\ You can get these values from your Internet provider. You
can also view these values on most Windows computers.
For instructions, see "Getting the Network Settings
Values." on this page.
5 . When done, highlight OK, and then press
v button. The product verifies the network
connection and then connects to the
network.
< Getting the Network Settings Values >
You can view your Network Settings values on
most Windows computers. To view the Network
Settings values, follow these steps:
• Windows XP
1 . Right click the Network icon on the bottom
right of the Windows desktop.
2 . In the pop-up menu, click Status.
3 . On the dialog that appears, click the Support
tab.
4 . On the Support tab, click the Details button.
5 . The Network settings are displayed.
0.0.0.0
Previous • Windows 7
0.0.0.0
IP Settings
0.0.0.0
1 . Click the Network icon on the bottom right of
0.0.0.0
Retry
the Windows desktop.
OK
2 . In the pop-up menu, click Network and
Sharing Center.
3 . On the dialog that appears, click the Local
Area Connection or Wireless Network
Connection depending on your network
connection.
4 . On the Support tab, click the Details button.
The Network settings are displayed.
| NOTE
\ Depending on your Windows version, the information may
differ.
Wireless Network
You can setup a wireless network connection in
three ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
When you configure the wireless network
connection, any wireless network devices currently
connected through the product or, if applicable,
the product's current wired connection, will be
disconnected.
|
33
|
English