4: Connecting The Ac Power Cord - Sony HT-K5 Operating Instructions Manual

Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
4: Connecting the AC
power cord
Setting the voltage selector
for the receiver and sub
woofer
If your receiver and sub woofer has a voltage
selector on the rear panel, check that the voltage
selector is set to the local power supply voltage.
If not, use a screwdriver to set the selector to the
correct position before connecting the AC power
cord to a wall outlet.
Receiver
120V 220V
VOLTAGE SELECTOR
Sub woofer
VOLTAGE SELECTOR
240V
220V
240V
120V
continued
13
GB