Polaris 550 Indy Owner's Manual page 45

Left Hand Control Alignment
1. Loosen the four control block mounting screws.
CAUTION! Take care to avoid damaging hand warmer/brake switch wires
when moving components.
2. Move the control block to the
desired position.
NOTE: If the control is loose and
was inadvertently moved
without loosening the
screws, move the control
block slightly to the left or
right to relocate the pins.
3. Tighten the screws to
specification in the sequence
shown in the image. Do not
over-torque.
Torque: 24 in-lbs (2.7 Nm)
Throttle Block Alignment
1. Slightly loosen the set screw on the
bottom of the housing.
2. Move the control block to the desired
position.
NOTICE: Take care to avoid damaging hand
warmer wires when moving
components.
3. Tighten the screw to specification. Do
not over-torque.
Torque: 35 in-lbs (4 Nm)
4. With the engine off, test throttle lever movement after tightening the
screw. See page 62.
THE PERFECT FIT
Control Block
1
4
2
3
Throttle Block
Set Screw
43