Hotpoint FZ78 Instruction Book page 13

Replace Lower Door
10. Use a thin blunt instrument to remove
top and bottom hinge bushes and
blanking plug from the door, taking care
not to mark the handle. Reposition on
opposite side.
11. Slide door upwards, locate hinge bush
onto centre hinge pin.
12. Fit bottom hinge and spacing washer
into bottom hinge bush, ensuring door is
aligned to cabinet sides.
14. Carefully stand appliance upright in
required location. Adjust front feet until
all four feet are in firm contact with the
floor and the appliance does not rock
(see Adjusting the Feet on page 5).
Replace Top Door
15. With a thin blunt instrument, remove
both top and bottom hinge bushes and
blanking plug taking care not to mark
the handle. Reposition on the opposite
side.
16. Replace
spacing
washers
onto the
centre
hinge pin.
17. Locate
base of
door onto
centre
hinge pin
(Fig 18),
slide top
left hinge into bracket, support door and
secure with screw.
18. Align top door and tighten centre hinge
screws.
Note: Replace items/fittings, stabilise
appliance and stand upright in final resting
position for at least 15 minutes before
switching on.
Alternatively you may wish to call
Service UK: 08709 066 066 or
Republic of Ireland: 1850 302 200 for a
quote on a Hotpoint Engineer carrying
out the conversion for you.
Fig 17
Fig 18
13. Replace
adjustable
feet
(Fig 17)
allowing
35mm
from the
bottom
of the
cabinet
to the
base of
the feet.
13