Plug Connections; Threading And Feeding Welding Wire - Miller AA40GB w/OCP Owner's Manual

3-6. Plug Connections

2

3-7. Threading And Feeding Welding Wire

Tools Needed:
Pressure
Adjust
JOG
Push wire thru guide up to drive rolls; continue to
hold welding wire. Press power source Jog push
button until drive rolls grab wire. Adjust tension until
wire does not slip. Indicator is for reference only.
OM-223 426 Page 14
1
3
Welding Power Source
ON
PURGE
V
OFF
JOG
POWER
Turn on power at welding power source.
Pressure
Adjust
WOOD
Press Jog push button until wire comes
out of gun. Feed wire to check drive roll
pressure. Adjust knob enough to pre-
vent slipping.
1 Weld Control
2 Motor Control Cord (Not
Supplied)
Cord is available in 20 ft (6.1 m),
30 ft (9.1 m) or 50 ft (15.2 m)
lengths.
3 Motor/Drive Assembly
To make connections, align key-
way, insert plug, and tighten
threaded collar.
804 104-C
Hold wire tightly to keep it
from unraveling.
6 in
(150 mm)
Pull and hold wire; cut off end.
Cut off wire. Close cover.
Ref. 804 391-A / Ref. 156 798 / 802 914