Panasonic DMC-FX60 Operating Instructions Manual page 15

Note
•
Remove the battery after use. Store the removed battery in the battery case (supplied).
•
Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the
settings on the camera may not be stored properly.
•
The supplied battery is designed only for the camera. Do not use it with any other equipment.
•
Before removing the card or battery, turn the camera off, and wait until the status indicator has
gone off completely. (Otherwise, this unit may no longer operate normally and the card itself
may be damaged or the recorded pictures may be lost.)
∫ Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery
Ensure that the AC adaptor (optional) and DC
coupler (optional) are purchased in a set. Do not
use if sold separately.
1 Open the card/battery door.
2 Insert the DC coupler, being careful of the
direction.
3 Close the card/battery door.
•
Ensure that the card/battery door is closed.
4 Open the DC coupler cover A.
•
If it is difficult to open, push open the coupler cover
from the interior with the card/battery door in an
open state.
5 Plug the AC adaptor into an electrical outlet.
6 Connect the AC adaptor B to the [DC IN] socket
C of the DC coupler.
D Align the marks and insert.
•
Ensure that only the AC adaptor and DC coupler for this
camera are used. Using any other equipment may
cause damage.
Note
•
Always use a genuine Panasonic AC adaptor (optional).
•
When using an AC adaptor, use the AC cable supplied with the AC adaptor.
•
Some tripods cannot be attached when the DC coupler is connected.
•
This unit cannot be stood upright when the AC adaptor is connected. When placing it down and
operating, we recommend placing it on a soft cloth.
•
Make sure to unplug the AC adaptor when you open the card/battery door.
•
If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
•
Also read the operating instructions for the AC adaptor and DC coupler.
•
We recommend you use a battery with sufficient battery power or the AC adaptor when
recording motion pictures.
•
If while recording motion pictures using the AC adaptor the power supply is cut off due to a
power cut or if the AC adaptor is disconnected etc., the motion picture being recorded will not
be recorded.
Downloaded from ManualsCamera.com Manuals
Preparation

- 15 -
