Description Of The Controls - Hyundai HS 210 Instruction Manual

Hair straightener
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 14
• This appliance is not intended for use by persons people (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instructions concerning the way of use of the appliance by
a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.

DESCRIPTION OF THE CONTROLS

P1
Main switch
P2
Temperature setting
P3
Handle
P4
Indicator ON
P5
High tepmerature area
P6
Lock
INSTRUCTIONS FOR USE
1) Before use the hair straightener, clean the hair with appropriate shampoo and wash with
warm water to clean the hair. Then dry the hair. Not completelly dry, leave it damp.
2) Smear the thermoplastic softening cream evenly to hair (it is optional when hair is in 20 %
wet condition) from the upper of the hair to the lower and then dry it naturally for 15 minutes.
3) Straightening your hair
After connecting the power supply, turn the switch to „ON". LED indicates power on. Make
sure the LED lights. In another case, make sure the power cord is connected. Turn the ther-
mostat to set the desired temperature.
Never leave the appliance unattended when it is plugged in.
Never put the appliance on a surface that is not heat-resistant when it is heating up
and whenit is hot.
4) Comb or brush your hair so that it is disentangled and smooth.
Use a comb to divide the hair into sections. Do not put too much hair in one section.
Tip: it is better to section off the crown area and to straighten the hair underneath first.Then
straighten the top area.
5) Take a section that is not wider than 5 cm. Place it between the straightening plates and pre-
ss the handles of the appliance firmly together.
6) Slide the straightener down the length of the hair for 5 seconds, from root to hair end, wit-
hout stopping to prevent overheating.
7) Repeat this process until you have achieved the desired look.
ENG - 15
ENG

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs 212

Table of Contents