Maintenance Warning - Black & Decker LHT341 Instruction Manual

k
5. PowercuT TM – If you encounter a
jam, depress the POwERCUT
(4) shown in figure l. The blades will
move back and forth in a slower, more
forceful rhythm to help cut through difficult
branches. Release the button to return to
normal hedge trimming usage.
noTe: Once the button is released, the
blades will immediately return to full speed.
noTe: The blades will stop when the button
is held for 15 seconds. To reengage the
POwERCUT TM feature, release the button and
depress it again.
DO NOT continuously hold the POwERCUT
button during normal hedge trimming.
l
warnInG:
INJURY, OBSERVE THE FOLLOwING:
• READ INSTRUCTION MANUAL
BEFORE USING. SAVE INSTRUCTION
MANUAL.
• CHECk THE HEDGE FOR FOREIGN
OBJECTS SUCH AS wIRE OR
FENCES BEFORE EACH USE.
• KEEP HANDS ON HANDLES. DON'T
OVERREACH.
• DO NOT USE UNDER WET
CONDITIONS.
cauTIon:
Blade May coaST
afTer Turn off.
danGer:
keeP HandS away
froM BladeS.
MaInTenance
warnInG:
PACk BEFORE SERVICING, CLEANING OR
REMOVING MATERIAL FROM THE
TM button
TO GUARD AGAINST
REMOVE BATTERY
GARDENING APPLIANCE.
The cutting blades are
made from high quality,
hardened steel and
with normal usage,
they will not require
resharpening. However,
if you accidentally hit a
wire fence (figure M),
stones, glass or other
hard objects, you may
put a nick in the blade. There is no need
to remove this nick as long as it does not
interfere with the movement of the blade.
If it does interfere, remove the battery and
use a fine toothed file or sharpening stone
to remove the nick. If you drop the trimmer,
carefully inspect it for damage. If the blade
is bent, housing cracked, or handles
broken or if you see any other condition
that may affect the trimmer's operation
contact your local BLACk+DECkER
Service Center for repairs before putting it
back into use.
Fertilizers and other garden chemicals
contain agents which greatly accelerate
TM
the corrosion of metals. Do not store
the unit on or adjacent to fertilizers or
chemicals.
with the battery removed, use only mild
soap and a damp cloth to clean the unit.
Never let any liquid get inside the unit;
never immerse any part of the unit into a
liquid. Prevent the blades from rusting by
applying a film of light machine oil after
cleaning.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
noTe: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning
the equipment off and on, the user is
9
M