Airstream 2011 FLYING CLOUD Owner's Manual page 90

ELECTRICAL
Rotate antenna until pointer on directional handle aligns with pointer on ceiling
plate.
NOTICE:
Antenna must be in "down" position while traveling to prevent
damage.
Turn elevating crank in the "Down" direction until resistance is noted. Antenna
is now locked in travel position.
Checking Operation:
G
1. Tune TV receiver to nearest station and rotate antenna for best picture and
sound.
2. Turn off switch on power supply. Picture on TV receiver should be consider-
ably degraded with the power off.
DO'S
1. Do check parking location for obstructions before raising antenna.
2. Do carefully raise, lower and rotate - if difficult, check for cause.
3. Do rotate slowly when selecting station and check fine-tuning on TV set
to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
DON'TS
1. Don't force elevating crank up or down. Check for cause of trouble.
2. Don't rotate directional handle hard against stops.
3. Don't travel with lift in up position.
4. Don't leave lift part way up or down.
5. Don't apply sealing compound or paint over top of base plate or anywhere
on lift.
Maintenance
Lubrication
To lubricate the elevating gear apply a liberal amount of silicone spray lubricant
to the elevating gear with the lift in the down position, then run the lift up and
down a few times to distribute lubricant over gears.
Lubricating Rotating Gear Housing
In the event that rotating the antenna becomes difficult, lubricating the bear-
ing surface between the rotating gear housing and the base plate can restore
normal operation. Any spray type silicone lubricant may be used.
G - 8