Advertisement
in accordance with the diagram shown in (fi g. 1). To fi t the
appliance correctly, align the front panel of the cooker hood
with the cabinet door and adjust spacer L using screws P (fi g.
2), then ensure the appliance meets the cabinet at the rear.
• Extraction through an outside wall
The appliance expels the fumes through an outside wallor a
duct. It is necessary to buy a telescopic pipe inaccordance
with the standards in use (infl ammable) andconnect it to
fl ange B (Fig 3).
• Recirculation
To transform the cooker hood from the extraction version
to the re circulating one ask your supplier for an activated
carbon fi lter.
The fi lter must be fi tted to the extracting group cooker hood
in the centre of the fan grille by twisting it by 90 degrees
until it is gripped securely (Fig 6). For this operation remove
the anti-grease fi lter(s) G (Fig 5). The clean air is returned
into the room through a connecting tube passing inside the
cupboard and connected to the ring B (fi g 4).
USE AND MAINTENANCE
• We recommend that the cooker hood is switched on before
any food is cooked.
We also recommend that the appliance is left running for
15 minutes after the food is cooked, in order to thoroughly
eliminate all contaminated air.
The eff ective performance of the cooker hood depends on
constant maintenance; the anti-grease fi lter and the active
carbon fi lter both require special attention.
• The anti-grease fi lter is used to trap any grease particles
suspended in the air, therefore is subject to saturation (the
time it takes for the fi lter to become saturated depends on
the way in which the appliance is used).
- To prevent potential fi re hazards, the anti-grease fi lters should
be washed a minimum of every 2 months (it is possible to use
the dishwasher for this task).
- After a few washes, the colour of the fi lters may change. This
does not mean they have to be replaced.
If the replacement and washing instructions are not followed,
the anti-grease fi lters may present a fi re hazard.
• The active carbon fi lters are used to purify the air which is
released back into the room.
The fi lters are not washable or re-usable and must be replaced
at least once every four months.
The active carbon fi lter saturation level depends on the fre-
quency with which the appliance is used, the type of cooking
performed and the regularity with which the anti-grease
fi lters are cleaned.
• Clean the cooker hood frequently, both inside and outside,
using a cloth which has been dampened with denatured
alcohol or neutral, non-abrasive liquid detergents.
• The light on the cooker hood is designed for use during
cooking and not for general room illumination.
Extended use of the light reduces the average duration of
the bulb.
• Replacing halogen light bulbs (Fig. 7).
To replace the halogen light bulbs B, remove the glass pane
C using a lever action on the relevant cracks.
Replace the bulbs with new ones of the same type.
Caution: do not touch the light bulb with bare hands.
•Commands: (pic.8) Slider the key symbols are explained
below:
A = Light switch
A1 = Off key
A2 = On key
B = Speed control
B1 = Off key
B2 = FIRST SPEED key
B3 = SECOND SPEED key
B4 = THIRD SPEED key
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 19 -
Advertisement
