Advertisement
amplifier power wire ring over the bolt, and tighten the nut back down with the
terminal on the battery. This is the primary power supply for your new amplifier.
Connect the other side of the power wire to the +B terminal on the amplifier. ONLY
when both sides of the wire are connected should you install the included fuse into the
in-line.
Remote Turn-On Wire (Smaller gauge Blue Wire): Connect to Turn On terminal of
new amplifier.
It is important to remember here that we are essentially "T'ing" into the
•
factory wires. It is important that the factory signal flow be allowed to continue
back into the factory amplifier.
For connection instructions, both written and visual, please see the next
•
section "Audio Input Connections". Both the remote turn on and audio
input connections are made in the same manner.
In the large plug going into the factory amplifier, we'll need to find the remote turn on
wire. You'll notice a large black housing around the plug, with two separate plugs
inside of this black housing.
The wire we'll be looking for is in the GREY plug. It's a small gauge White wire.
Advertisement
