Rotary Hammer Safety Warnings; Specifications; Standard Accessories; Optional Accessories (Sold Separately) - Hitachi DH 38MS Handling Instructions Manual

ROTARY HAMMER SAFETY WARNINGS

1. Wear ear protectors.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and could
give the operator an electric shock.

SPECIFICATIONS

Voltage (by areas)*
Power input
Capacity
No-load speed
Full-load impact rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case .............................................................................1
(2) Side Handle ..................................................................1
Standard accessories are subject to change without notice.

OPTIONAL ACCESSORIES (sold separately)

1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
Outer diameter (mm)
16
19
22
25
28
32
38
2. Anchor hole drilling (Rotation + Hammering)
Drill bit (Taper shank)
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
Overall length (mm)
340, 540
320, 520
370, 570
(3) Cotter
(2) Taper shank
adapter
(SDS max shank)
4. Do not touch the bit during or immediately after operation.
The bit becomes very hot during operation and could
cause serious burns.
5. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
6. Always hold the body handle and side handle of the
power tool fi rmly. Otherwise the counterforce produced
may result in inaccurate and even dangerous operation.
7. Wear a dust mask
Do not inhale the harmful dusts generated in drilling or
chiseling operation. The dust can endanger the health of
yourself and bystanders.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
950 W*
Drill bit: 38 mm
Core bit: 105 mm
620 /min
2800 /min
6.4 kg
Taper shank
Application drill bit
adapter
Morse taper Drill bit (taper shank)
(No. 1) 11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
Adapter for SDS-plus shank bit
(1) Drill bit
(SDS-plus shank)
3. Large dia. hole boring (Rotation + Striking)
(Guide (1) Center
plate) pin
(1) Center pin
● Applied to core bits from 38 mm to 105 mm
● Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
● External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm or
29 mm)
(3) Core bit shank
● Applied to core bits above 38 mm
● Applied to core bits below 35 mm
(2) Adapter for SDS-plus
shank bit
(SDS max shank)
(2) Core (3) Core bit
bit shank
3